Plan Review Details - Permit 99121998
Plan Review Stops For Permit 99121998
Review Stop E ELECTRICAL
Rev No 3 Status P Date 2000-12-21 Cont ID  
Sent By dpalmer Date 2000-12-21 Time 16:06 Rev Time 0.00
Received By dpalmer Date 2000-12-21 Time 16:06 Sent To  
Notes
***NONE***
Review Stop E ELECTRICAL
Rev No 2 Status P Date 2000-05-15 Cont ID  
Sent By dpalmer Date 2000-05-15 Time 12:40 Rev Time 0.00
Received By dpalmer Date 2000-05-15 Time 12:40 Sent To  
Notes
***NONE***
Review Stop E ELECTRICAL
Rev No 1 Status P Date 2000-02-22 Cont ID  
Sent By dpalmer Date 2000-02-22 Time 07:08 Rev Time 0.00
Received By dpalmer Date 2000-02-22 Time 07:08 Sent To  
Notes
***NONE***
Review Stop M MECHANICAL (A/C)
Rev No 3 Status P Date 2000-05-03 Cont ID  
Sent By cthirben Date 2000-05-03 Time 13:29 Rev Time 1.00
Received By cthirben Date 2000-05-03 Time 13:29 Sent To  
Notes
***NONE***
Review Stop M MECHANICAL (A/C)
Rev No 2 Status P Date 2000-02-26 Cont ID  
Sent By jleech Date 2000-02-26 Time 09:26 Rev Time 0.35
Received By jleech Date 2000-02-26 Time 09:26 Sent To  
Notes
***NONE***
Review Stop M MECHANICAL (A/C)
Rev No 1 Status F Date 2000-01-28 Cont ID  
Sent By jleech Date 2000-01-28 Time 14:37 Rev Time 0.35
Received By jleech Date 2000-01-28 Time 14:37 Sent To  
Notes
2001-01-08 00:00:00DENIED;
 1. A/C PLAN TOBE SAME AS BUILDING FLOOR
 PLAN.
 2. CFM CALCULATIONS SHOULD BE LESS THAN
 A/H'S CAPACITYOR LARGER EQUIPMENT
 SHOULD BE USED.
Review Stop P PLUMBING
Rev No 3 Status P Date 2000-05-17 Cont ID  
Sent By tlarge Date 2000-05-17 Time 06:26 Rev Time 0.50
Received By tlarge Date 2000-05-17 Time 06:26 Sent To  
Notes
2001-01-08 00:00:00SAME COMMENTS AS PREVIOUS REVIEW.
Review Stop P PLUMBING
Rev No 2 Status F Date 2000-05-04 Cont ID  
Sent By tlarge Date 2000-05-04 Time 17:20 Rev Time 0.75
Received By tlarge Date 2000-05-04 Time 17:20 Sent To  
Notes
2001-01-08 00:00:00SHT.1-MAX.HEIGHT TO BOTTOM OF WOOD
 BLOCKING FOR SIDE OF TOILET SHALL BE 32"
 (PLANS SHOW 32" MIN.)PER FHA REQ.#6,FIG.
 #3.
  
 CLEARLY INDICATE ON THE PLANS WHICH
 DESIGN SPECIFICATION (A OR B)OF THE FAIR
 HOUSING ACT IS BEING UTILIZED.
  
 BATHROOM #2,UNIT MDL-1409-LENGTH OF THE
 BATHROOM DOESN'T HAVE THE DIMENSION
 REQUIRED FOR TYPE "A"BATH WHEN
 APPROACHED FROM THE BEDROOM.
  
 THE LOCATION OF THE PLUMBING FIXTURES ON
 THE SANITARY RISERS SHALL CORRELATE W/
 THE ARCH.FLOOR PLAN.COUNTYWIDE AMEND-
 MENTS TO SPC SEC.104.2.1.
Review Stop P PLUMBING
Rev No 1 Status F Date 2000-01-27 Cont ID  
Sent By tlarge Date 2000-01-27 Time 07:24 Rev Time 0.75
Received By tlarge Date 2000-01-27 Time 07:24 Sent To  
Notes
2001-01-08 00:00:00A 30"X 48"CLEAR FLOOR SPACE SHALL BE
 PROVIDED PARALLEL TO THE SHOWER PER
 FEDERAL FAIR HOUSING ACT 24 CFR 100.205
 REQ.#7,PARAGRAPH (2)(A).THE WATER CLOSET
 CANNOT BE LOCATED IN THIS SPACE PER
 SPECIFICATION"A"OF THE ACT.
  
 SHOW MAX.HEIGHT TO BOTTOM OF WOOD
 BLOCKING FOR GRAB BARS.COMPLY W/FHA REQ.
 #6.
  
 THE LOCATION OF THE FIXTURES ON THE
 SANITARY RISER DOESN'T CORRELATE W/THE
 ARCH.FLOOR PLAN.COUNTYWIDE AMENDMENTS
 TO SPC SEC.104.2.1.
Review Stop R ROOF PLAN REVIEW
Rev No 2 Status P Date 2000-05-11 Cont ID  
Sent By jgomez Date 2000-05-11 Time 21:40 Rev Time 2.50
Received By jgomez Date 2000-05-11 Time 21:39 Sent To  
Notes
2001-01-08 00:00:00APPROVED WITH PROVISO:
 1-FLOOD ZONE "A0". PROVIDE ELEVATION
 CERTIFICATE AFTER SLAB IS POURED.
 2-PRODUCT APPROVALS:
 -PROVIDE PRODUCT APPROVAL FOR TWO HOUR
 FIRE RATED CONCRETE BLOCK, EXTERIOR
 FRENCH DOOR WITH SIDELITES ASSEMBLY,
 EXTERIOR DOUBLE FRENCH DOOR, AND
 WINDOW MULLIONS.
 -DRAWINGS IN PRODUCT APPROVAL FOR THE
 SLIDING GLASS DOORS ARE NOT LEGIBLE.
 3-PROVIDE BUCK DETAIL FOR SLIDING GLASS
 DOORS. SEC. 104.2.2 CITY AMENDMENTS.
 4-PRODUCT APPROVAL FOR SINGLE HUNG
 WINDOWS REQUIRES A 2X BUCK. REVISE
 WINDOW BUCK DETAIL AS REQUIRED.
 5-STORM PANELS:
 -INSTALLATION SCHEDULE AND KEY PLAN
 DON'T MATCH ARCHITECT'S PLANS. SEE
 SIZES OF OPENINGS. ALSO, INSTALLATION
 SCHEDULE AND KEY PLAN TO INCLUDE ALL
 OPTIONS SHOWN BY THE ARCHITECT.
 -CLEARLY INDICATE ON DRAWINGS MOUNTING
 CONDITIONS AND ANCHOR TYPE AND SPACING
 NOTE: TAKE INTO CONSIDERATION TABLES
 ON SHEET 4 OF 4 OF DRAWING 97-404P AND
 BUILDING CONSTRUCTION. THE MEAN ROOF
 HEIGHT FOR THIS BUILDING IS PLUS OR
 MINUS AT 16'-0" AND THE BUILDING CONST
 IS MASONRY, NOT CONCRETE.
 6-REVISE ENERGY CALCULATIONS:
 -OWNER INFORMATION IS INCORRECT.
 -LOCATION IS INCORRECT.
 -DON'T FORGET OWNER' SIGNATURE AND DATE
 7-PROVIDE COMPLETE CALCULATIONS FOR
 ATTIC CROSS VENTILATION AT EACH UNIT
 AND CLEARLY INDICATE ON ROOF PLAN THE
 VENT SIZES AND LOCATION.SEC 2309.7 SBC
 8-PROVIDE COMPLETE DETAIL/SPECIFICATIONS
 FOR CEILING CONSTRUCTION AT ENTRY AND
 BACK PORCHES OF EACH UNIT. INCLUDE
 FASTENER TYPE AND SPACING.SEC 2504 SBC
 9-WALK-IN-CLOSET IN UNITS 1527 TO HAVE
 THE SHELF ONLY (NO ROD) ON EITHER SIDE
 IN ORDER TO COMPLY WITH THE CLEARANCES
 ON THE FAIR HOUSING ACT, CHAPTER THREE
Review Stop R ROOF PLAN REVIEW
Rev No 1 Status F Date 2000-03-27 Cont ID  
Sent By jgomez Date 2000-03-27 Time 20:14 Rev Time 3.00
Received By jgomez Date 2000-03-27 Time 20:14 Sent To  
Notes
2001-01-08 00:00:00CHECKLIST:
 1-REVISE LOCATION OF KITCHEN RANGE TO
 COMPLY WITH THE CLEAR SPACE REQUIRED
 IN FRONT OF IT. SEE SECTION 7A OF FAIR
 HOUSING ACT.
 2-BATHRM #2, UNIT MDL 1409, SEC 7B F.H.A
 A)DOOR FROM BEDROOM #2 TO BE 32" CLEAR.
 B)LENGTH OF BATHROOM DOESN'T HAVE THE
 DIMENSION REQUIRED FOR A TYPE A BATH
 WHEN APPROACHED FROM THE BEDROOM.
 3-SHOWER AT MASTER BATH TO COMPLY WITH
 THE CLEAR FLOOR SPACE REQUIRED. 7B FHA
 4-OPTIONAL SLIDING GLASS DOORS AT MASTER
 BEDROOM TO HAVE 32" MIN. CLEAR OPENING
 5-ENTRY DOOR SPACE TO COMPLY W/ANSI 4.13
 6-ROOF FRAMING PLANS AND TRUSS DRAWINGS:
 -CLARIFY CONSTRUCTION AT RIGHT AND LEFT
 ENDS OF BUILDINGS. TRUSS DRAWINGS SHOW
 BEARING WALLS, BUT ARCHITECTURAL DWGS
 DON'T. SEE PLANS FOR COMMENTS.
 -CLARIFY WHO REVIEW THE TRUSS DRAWINGS.
 STAMP SAYS "OUR OFFICE HAS REVIEW..."
 WHAT OFFICE IS THIS?.
 -CLARIFY WHY THE MAIN TRUSSES RUNNING
 FROM FRONT TO BACK ARE DESIGNED
 WITHOUT THE RIDGE LINE. WHY IS THIS
 AREA TO BE DONE BY BUILDER?
 -UPDATE ALL GENERAL TRUSS DETAILS. ASCE
 7-95 AND SEAL, SIGN AND DATE THEM.
 -ENGINEERED TRUSSES TO BE DESIGNED PER
 ASCE 7-95 FOR 145 MPH WIND, NOT AS PER
 ASCE 7-93 FOR 140 MPH WIND. ALSO, ALL
 TRUSSES TO BE DESIGNED AT THE SAME
 MEAN ROOF HEIGHT.
 -REVISE TRUSS ANCHOR SCHEDULE TO RESIST
 THE UPLIFT AND LATERAL LOADS SHOWN ON
 THE ENGINEERED TRUSSES.
 7-PRODUCT APPROVALS:
 -PROVIDE PRODUCT APPROVAL FOR 2 HOUR
 CONCRETE BLOCK.
 -SLIDING GLASS DOORS AND WINDOW PRODUCT
 APPROVALS TO BE SIGNED,SEALED & DATED
 BY THE PROFESSIONAL DESIGNER OF RECORD
 AND FILL IN THE SPECIFIC JOPB LOCATION
 8-STORM PANELS:
 -PROVIDE A COMPLETE INSTALLATION SCHED.
 (AS PER CITY SAMPLE) AND KEY PLAN.
 ALSO, HIGHLIGHT SPECIFIC MOUNTING
 CONDITIONS AND ANCHORS SPACING.
 9-ENERGY CALCULATIONS TO BE SIGNED AND
 DATED BY THE OWNER/AGENT. ALSO, REVISE
 THE OWNER INFORMATION ON TOP OF FORM.
 -NUMBER OF BEDROOMS ON UNIT 1527 IS 3,
 NOT 2. REVISE AS REQUIRED.
 10-PROVIDE CALCULATIONS FOR ATTIC CROSS
 VENTILATION AT EACH UNIT.SBC/97 2309.7
 NOTE: TAKE INTO ACCOUNT FIREPROOF DET.
 ON WALL SECTION 1 OF SHEET NAMED DT.
 11-PROVIDE COMPLETE DETAIL AND SPECS FOR
 CEILING CONSTRUCTION AT ENTRY AND BACK
 PORCHES OF EACH UNIT. INCLUDE FASTENER
 TYPE AND SPACING.SECTION 2504.2 SBC/97
 12-DRAWING #4: CLARIFY HOW DOES THE 2 HR
 "PARTY WALL" GOES TO THE BOTTOM OF
 ROOF SHEATHING IF THE BEAM HEIGHT IS
 12'-11". SEE SECTIONS AND ELEVATIONS.
 13-DETAIL SC-2: HOW DOES THIS DESIGN
 MAINTAINS THE STRUCTURAL STABILITY AND
 FIRE RESISTANCE IF THE MAIN GIRDER
 FAILS. SEC 704.4.2(3) SBC 1997.
 14-NEED TO HAVE A PERMIT APPLICATION FOR
 EACH TOWNHOUSE.
 NOTE:NO NEED FOR INDIVIDUAL DWGS, JUST
 2 SETS FOR ENTIRE BUILDING.
 15-PAY $750 TO THE CITY OF WEST PALM BCH
 FOR WESTERN EXPANSION FEES FOR EACH
 TOWNHOUSE.
 16-CONSTRUCTION VALUATION DECLARED IN
 THE PERMIT APPLICATION IS TOO LOW. THE
 RECALCULATED VALUE FOR EACH TOWNHOUSE
 IS AS FOLLOWS:
 $104,640 FOR MODEL 1357
 $107,877 FOR MODEL 1409 AND
 $115,660 FOR MODEL 1527.
 THEREFORE, PERMIT FEES TO BE ADJUSTED
 FOR EACH PERMIT APPLICATION
 17-PROVIDE SAFETY GLASS AT AREAS MARKED
 ON PLANS. SECTION 2405.2 SBC 1997.
 18-SEE ADDTIONAL COMMENTS MARKED ON THE
 PLANS AND PLEASE RETURN REVIEWED SET
 AFTER CORRECTIONS ARE DONE IN ORDER TO
 FACILITATE AND EXPEDITE THE RE-REVIEW
 PROCESS.
Review Stop Z ZONING
Rev No 1 Status P Date 2000-02-28 Cont ID  
Sent By gjoyce Date 2000-02-28 Time 10:41 Rev Time 0.25
Received By gjoyce Date   Time   Sent To  
Notes
***NONE***


Account Summary | Usage Policy | Privacy Policy
Copyright © 2005 – 2014, SunGard Pentamation, Inc & City of West Palm Beach, FL – All Rights Reserved