| 2015-12-21 11:50:54 | CHRISTOPHER S. THROOP, C.B.O. |
| | BLDG. PLANS EXAMINER ? PX3169 |
| | (561) 805-6718 |
| | [email protected] |
| | |
| | PROVIDE DETAIL AND DESCRIPTION OF EXT WALLS. |
| | DEMONSTRATE HOW LOAD TRANSFER FROM ROOF TO FOUNDATION |
| | IS ACHIEVED. |
| | |
| | 107.2.1 INFORMATION ON CONSTRUCTION DOCUMENTS. |
| | CONSTRUCTION DOCUMENTS SHALL BE DIMENSIONED AND DRAWN |
| | UPON SUITABLE MATERIAL. CONSTRUCTION DOCUMENTS SHALL BE |
| | OF SUFFICIENT CLARITY TO INDICATE THE LOCATION, NATURE |
| | AND EXTENT OF THE WORK PROPOSED AND SHOW IN DETAIL THAT |
| | IT WILL CONFORM TO THE PROVISIONS OF THIS CODE AND |
| | RELEVANT LAWS, ORDINANCES, RULES AND REGULATIONS, AS |
| | DETERMINED BY THE BUILDING OFFICIAL. SUCH DRAWINGS AND |
| | SPECIFICATIONS SHALL CONTAIN INFORMATION, IN THE FORM |
| | OF NOTES OR OTHERWISE, AS TO THE QUALITY OF MATERIALS, |
| | WHERE QUALITY IS ESSENTIAL TO CONFORMITY WITH THE |
| | TECHNICAL CODES. SUCH INFORMATION SHALL BE SPECIFIC, |
| | AND THE TECHNICAL CODES SHALL NOT BE CITED AS A WHOLE |
| | OR IN PART, NOR SHALL THE TERM "LEGAL" OR ITS |
| | EQUIVALENT BE USED AS A SUBSTITUTE FOR SPECIFIC |
| | INFORMATION. ALL INFORMATION, DRAWINGS, SPECIFICATIONS |
| | AND ACCOMPANYING DATA SHALL BEAR THE NAME AND SIGNATURE |
| | OF THE PERSON RESPONSIBLE FOR THE DESIGN. (SEE ALSO |
| | SECTION 107.3.5). |
| | |
| | 2104.1.4 CHASES AND RECESSES. MASONRY |
| | CHASES AND RECESSES SHALL BE CONSTRUCTED AS MASONRY |
| | UNITS ARE LAID. MASONRY DIRECTLY ABOVE CHASES OR |
| | RECESSES WIDER THAN 12 INCHES (305 MM) SHALL BE |
| | SUPPORTED ON LINTELS. |
| | |
| | 2308.8.3 FRAMING AROUND OPENINGS. WOOD |
| | TRIMMER AND HEADER JOISTS SHALL BE DOUBLED, OR OF |
| | LUMBER OF EQUIVALENT CROSS SECTION, WHERE THE SPAN OF |
| | THE HEADER EXCEEDS 4 FEET (1219 MM). THE ENDS OF HEADER |
| | JOISTS MORE THAN 6 FEET (1829 MM) LONG SHALL BE |
| | SUPPORTED BY FRAMING ANCHORS OR JOIST HANGERS UNLESS |
| | BEARING ON A BEAM, PARTITION OR WALL. TAIL JOISTS OVER |
| | 12 FEET (3658 MM) LONG SHALL BE SUPPORTED AT THE HEADER |
| | BY FRAMING ANCHORS OR ON LEDGER STRIPS NOT LESS THAN 2 |
| | INCHES BY 2 INCHES (51 MM BY 51 MM). |
| | |
| | |
| | |
