| Date |
Text |
| 2021-09-07 08:32:03 | COMMENTS FROM THE 1ST REVIEW LISTED BELOW WERE NOT |
| | ADDRESSED. PLEASE COMPLY. |
| | |
| | ROOFING |
| | REVIEWED BY ROGER MCPHERSON |
| | 561-805-6716 |
| | [email protected]. |
| | CODE USED FOR REVIEW - 2020 FBC WITH WPB CHAPTER 1 |
| | AMENDMENT |
| | |
| | CORRECTIONS NEEDED - |
| | 1) IN THE PRODUCT APPROVAL PROVIDED FOR THE ROOFING - |
| | PLEASE CIRCLE THE ROOFING SYSTEM TO BE USED IN THE |
| | ROOFING PRODUCT APPROVAL - ROOFING SYSTEM TO BE USED ON |
| | THE PROVIDED PRODUCT APPROVAL MAY REQUIRE ADDITIONAL |
| | SIGNED AND SEALED ATTACHMENT DETAILS FROM AN ARCHITECT |
| | OR ENGINEER FOR ROOF WIND ZONES 2 AND 3 WHICH REQUIRE A |
| | HIGHER PRESSURE THAN THE MAXIMUM SHOWN ON THE PRODUCT |
| | APPROVAL - SEE GENERAL LIMITATION NOTE NUMBER 7 OR 9 ON |
| | THE PRODUCT APPROVAL. SHOW THE WIND DESIGN DATA USED ON |
| | THE ADDITIONAL ATTACHMENT DETAILS PER 2020 FBC AND ASCE |
| | 7-16 - WIND SPEED - EXPOSURE - RISK CATEGORY - ETC. |
| | 2) DRAWINGS PROVIDED NEEDS TO SHOW THE WIND DESIGN DATA |
| | USED FOR THE WIND DESIGN FBC 1603.1.4 - FBC WPB |
| | 107.2.1.1 |
| | 3) DRAWINGS PAGE 6 DETAIL "B" AND "C" NEED TO SHOW THE |
| | EDGE BLOCKING (WOOD NAILER SIZE) ATTACHMENT SIZE, |
| | LENGTH AND ON CENTER SPACING. FBC WPB 107.2.1.1 |
| | 4) PLEASE SHOW THE ROOF SLOPE AND BUILDING HEIGHT FBC |
| | WPB 107.2.1.1 |
| | 5) PLEASE PROVIDE A STRUCTURAL ANALYSIS FROM A DESIGN |
| | PROFESSIONAL SHOWING THAT THE EXISTING BUILDING CAN |
| | HANDLE THE ADDITIONAL ROOF LOADS - FBC EXISTING |
| | BUILDING 707.2 ADDITION OR REPLACEMENT OF ROOFING OR |
| | REPLACEMENT OF EQUIPMENT. WHERE ADDITION OR REPLACEMENT |
| | OF ROOFING OR REPLACEMENT OF EQUIPMENT RESULTS IN |
| | ADDITIONAL DEAD LOADS, STRUCTURAL COMPONENTS SUPPORTING |
| | SUCH REROOFING OR EQUIPMENT SHALL COMPLY WITH THE |
| | GRAVITY LOAD REQUIREMENTS OF THE FLORIDA BUILDING CODE, |
| | BUILDING. |
| | 6) DRAWING LABELED "PDC BUILDING H - PERMIT SET.PDF" IN |
| | PROJECTDOX "SUPORTING DOC" FOLDER IS A PACKAGE OF |
| | DRAWINGS - PLEASE SEPARATE THE PACKAGE OF DRAWINGS IN |
| | THE "DRAWING" FOLDER IN PROJECTDOX. |
| | |
