| Date |
Text |
| 2019-05-07 17:38:29 | RESIDENTIAL (R3) RE-ROOF, THIRD BUILDING REVIEW |
| | CHECKLIST. |
| | CODE: FBC 6TH EDITION (2017) AND CITY AMENDMENTS. |
| | |
| | 1- ACCORDING TO PALM BEACH COUNTY PROPERTY APPRAISER, |
| | THE VALUE OF THE STRUCTURE IS $319,214. THEREFORE, |
| | NEEDS TO COMPLY WITH THE ROOFF TO WALL CONNECTIONS AS |
| | REQUIRED BY SEC. 706.8 FBC-EXISTING BUILDING. SHOW |
| | COMPLIANCE. NOTE: A SEPARATE SUB-PERMIT IS REQUIRED FOR |
| | ROOF TO WALL CONNECTIONS. THIS WORK CAN NOT BE DONE BY |
| | THE ROOFING CONTRACTOR UNLESS ROOFING CONTRACTOR |
| | POSSESSES THE PROPER LICENSE TO PERFORM THIS WORK. |
| | |
| | RESPONSE: |
| | DAVE WIKEL- PRESIDENT OF THERMA SEAL ROOF SYSTEMS, LLC |
| | E-MAILED STATING THAT THE COST OF ROOF TO WALL |
| | CONNECTIONS EXCEEDS THE 15% OF THE ROOF WORK. |
| | PROPOSAL FROM MERCURIO CONSTRUCTION LLC SUBMITTED IS |
| | TOO GENERAL. ITEM #1 OF THE PROPOSAL STATES "REMOVE THE |
| | T AND G DECKING AROUND THE PERIMETER OF THE EXISTING |
| | HOUSE". PROVIDE PROPOSAL WITH COMPLETE BREAKDOWN OF THE |
| | ROOF TO WALL CONNECTIONS. PROVIDE COST FOR ROOF TO WALL |
| | CONNECTIONS AT ALL CORNER AND ROOF TO WALL CONNECTION |
| | AT THE REST OF THE HOUSE. CLEARLY STATE HOW MANY |
| | CORNERS ARE IN THIS HOUSE. AND, CLEARLY SPECIFY TYPE OF |
| | STRAP AND NUMBER OF NAILS. |
| | ( 3 NAILS ARE NOT ACCEPTABLE. SEE SEC. 706.8.1.5 |
| | FBC-EXISTING BUILDING). |
| | NOTE: IF THE COST TO INSTALL ROOF TO WALL CONNECTIONS |
| | AT ALL CORNERS EXCEEDS THE 15% OF THE ROOF WORK, THEN |
| | THE EXCEPTION APPLIES. |
| | |
| | |
| | EXCEPTION #2 OF SEC. 706.8.1 OF FBC-EXISTING BUILDING |
| | STATES THE FOLLOWING: |
| | "ROOF-TO-WALL CONNECTIONS SHALL NOT BE REQUIRED UNLESS |
| | EVALUATION AND INSTALLATION OF CONNECTIONS AT GABLE |
| | ENDS OR ALL CORNERS CAN BE COMPLETED FOR 15 PERCENT OF |
| | THE COST OF ROOF REPLACEMENT.". |
| | |
| | |
| | 2- ENGINEERING SUBMITTED FOR FLAT ROOF: |
| | A) OK. |
| | |
| | B) OK |
| | |
| | C) OK |
| | |
| | 3- OK |
| | |
| | 4- OK |
| | |
| | 5-- ROOFING UNDERLAYMENT FLORIDA PRODUCT APPROVALS |
| | FL14317-R10 SUBMITTED: |
| | A) CLEARLY MARK WHICH MAXIMUM DESIGN PRESSURES ASSEMBLY |
| | FORM SEC. 5.6.4 OF PRODUCT APPROVAL IS GOING TO BE |
| | USED. OR IF USING THE FRSA/TRI APRIL 2012 (04-12) |
| | REVISED EDITION, THEN PROVIDE COMPLETE INFORMATION |
| | SHOWING THE DETERMINATION OF DESIGN WIND LOADS AS |
| | REQUIRED BY SEC. 5.6.4. |
| | |
| | RESPONSE: |
| | ONLY COPY OF TABLE 1A OF FRSA/TRI SHOWING THE DESIGN |
| | PRESSURES WAS SUBMITTED. IT IS NOT CLEAR IF CONTRACTOR |
| | IS USING THE FRSI INSTALLATION GUIDELINES OR IF USING |
| | ANY OF THE SYSTEMS LISTED ON SEC. 5.6.4 OF FLORIDA |
| | PRODUCT APPROVAL SUBMITTED. IF USING ANY SYSTEM FROM |
| | THE PRODUCT APPROVAL, THEN CLEARLY MARK WHICH ONE. IF |
| | USING THE FRSA INSTALLATION GUIDELINES, THEN PROVIDE |
| | COMPLETE INFORMATION FROM THE FRSA GUIDELINES SHOWING |
| | UNDERLAYMENT INSTALLATION. |
| | NOTE: TALKED TO DIANA TO EXPLAIN HOW TO ADDRESS THIS |
| | COMMENT. |
| | |
| | 6- OK |
| | |
| | 7- OK |
| | |
| | |
| | PLEASE NOTE THAT SUBMITTAL OF ADDITIONAL AND/OR REVISED |
| | MATERIALS MAY RESULT IN NEW PLAN REVIEW COMMENTS. |
| | |
| | |
| | IF YOU HAVE ANY QUESTIONS, PLEASE CONTACT |
| | JULIO GOMEZ |
| | COMMERCIAL COMBINATION PLANS EXAMINER |
| | DEVELOPMENT SERVICES DEPARTMENT |
| | BUILDING DIVISION |
| | (561)805-6712 |
| | [email protected] |
| | |
| | |
