| Date |
Text |
| 2008-10-24 11:11:10 | GAS PLAN REVIEW: |
| | DENIED **2ND TIME: |
| | |
| | PLAN REVIEW UNDER THE 2004 FLORIDA BUILDING CODES WITH |
| | 2007 REVISIONS, CITY OF WEST PALM BEACH AMENDMENTS TO |
| | CHAPTER 1 (W.P.B.), FLORIDA ADMINISTRATIVE CODE |
| | (F.A.C.), AND FLORIDA STATUTES (F.S.). |
| | |
| | **THE FOLLOWING COMMENTS ARE NUMBERED TO CORRESPOND |
| | WITH THE PREVIOUS GAS REVIEW COMMENTS AS WELL AS THE |
| | DESIGNER'S RESPONSES FOR THE PURPOSE OF CONTINUITY. NEW |
| | COMMENTS WILL BE SO NOTED FOLLOWING THE PREVIOUS REVIEW |
| | COMMENTS. |
| | |
| | 1. SUBMIT AN ISOMETRIC DRAWING THAT |
| | CLEARLY SHOWS ALL CUT SECTIONS OF PIPE |
| | AND CORRESPONDING LENGTHS PER FBC-2004 |
| | FUEL GAS CODE SECTION 401.1 SCOPE. |
| | NOTE: THE SUBMITTED ISOMETRIC DOES NOT INDICATE |
| | CORRESPONDING LENGTHS TO ALL CUT SECTIONS OF PIPE. |
| | REFERENCE THE YELLOW HIGH LIGHTED CUT SECTIONS WITH NO |
| | CORRESPONDING LENGTHS INDICATED AND COMPLY ON THE |
| | RESUBMITTAL. |
| | |
| | **RESPONSE NOTED, HOWEVER THE RESUBMITTED PLANS STILL |
| | HAVE CUT SECTIONS OF PIPE WITH NO CORRESPONDING LENGTHS |
| | BEING INDICATED FOR THEM. IF THERE IS A CUT SECTION OF |
| | PIPE THERE SHOULD BE A CORRESPONDING LENGTH INDICATED |
| | FOR IT. PLEASE REFERENCE THE YELLOW HIGH LIGHTED CUT |
| | SECTIONS WITH NO CORRESPONDING LENGTHS INDICATED AND |
| | COMPLY ON THE RESUBMITTAL. |
| | |
| | 2. "OK" COMMENT ADDRESSED. |
| | |
| | 3. SHOW THE DISTANCE FROM THE POINT OF |
| | DELIVERY, (METER), TO THE MOST REMOTE |
| | OUTLET IN THE BUILDING AND/OR SYSTEM PER |
| | FBC-2004 FUEL GAS CODE APPENDIX A - USE |
| | OF CAPACITY TABLES A.3.1(4). |
| | NOTE: REFERENCE COMMENT #1 AND COMPLY. |
| | |
| | **RESPONSE NOTED, HOWEVER UNTIL COMMENT #1 IS ADDRESSED |
| | AND THE WRITTEN DISTANCES ARE CORRELATED WITH THE |
| | CORRESPONDING LENGTHS FOR EACH CUT SECTIONS OF PIPE |
| | THIS COMMENT WILL REMAIN. |
| | |
| | 4. SUBMIT COMBUSTION AIR CALCULATIONS FOR THE LIVING |
| | ROOM (ROOM #108) GAS FIRE PLACE PER FBC-2004 FUEL GAS |
| | CODE SECTION 304. |
| | |
| | **RESPONSE NOTED, HOWEVER THE CALCULATIONS PROVIDED IN |
| | THE RESPONSE LETTER SHOULD BE CLEARLY INDICATED ON PLAN |
| | SHEET P202. |
| | |
| | 5. SUBMIT MANUFACTURE SHEETS FOR ALL GAS |
| | EQUIPMENT TO VERIFY COMPLIANCE WITH |
| | STANDARDS NFPA 54, NFPA 58, AND THE |
| | FBC-2004 FUEL GAS CODE SEC 402.2. |
| | NOTE: THE MP REGULATORS MANUFACTURER SHEETS SHALL |
| | CLEARLY INDICATE THE MAKE, MODEL NUMBER, BTU LOAD |
| | CAPACITY AND A LISTING FROM A RECOGNIZED TESTING |
| | LABORATORY (LISTING EXAMPLES= CSA, AGA OR UL). THE |
| | SUBMITTED REAL-FYRE GAS LOG MANUFACTURE SHEETS DO NOT |
| | COMPLY WITH THE FOLLOWING. LOG LIGHTERS SHALL BE TESTED |
| | IN ACCORDANCE WITH CSA 8. PER FBC-2004 FUEL GAS CODE |
| | SECTION 603.1 GENERAL. |
| | |
| | **NO COMMENT RESPONSE AND THIS COMMENT WAS PARTIALLY |
| | ADDRESSED. MANUFACTURE SHEETS FOR THE MP REGULATOR WERE |
| | NOT IN THE RESUBMITTAL. |
| | |
| | **THE FOLLOWING IS A NEW COMMENT. |
| | |
| | 6. SHEET P202: THE FOLLOWING NOTE WAS ON THE |
| | RESUBMITTED GAS RISER "ALL CSST PIPING SHALL BE OMEGA |
| | TRACPIPE. SIZING BASED ON MANUFACTURE'S DESIGN |
| | STANDARDS AND ALLOWED BY 402.3(2)". PLEASE KNOW THAT |
| | THE OMEGAFLEX TRACPIPE TABLES DO NOT HAVE A EHD 30 |
| | LISTED IN THEIR TABLES NOR DO THEY HAVE AN APPROVED |
| | TABLE TO REVIEW TO. PLEASE KNOW THAT FOR 0.5 PSI |
| | NAT/GAS TABLE 402.4(14) FROM THE FBC-2004 FUEL GAS CODE |
| | WILL BE USED FOR PLAN REVIEW. PLEASE DELETE THE OMEGA |
| | TRACPIPE NOTE FROM THE PLANS. |
| | |
| | ********IMPORTANT INFORMATION******** |
| | WHEN RESUBMITTING PLANS, PLEASE PROVIDE A COPY OF THE |
| | OLD PLANS, CLEARLY INDICATE THE REVISION ON THE NEW |
| | PLANS, REMOVE AND REPLACE ANY PAGES AS NECESSARY. A |
| | TRANSMITTAL LETTER LISTING THE ORIGINAL REVIEW COMMENT |
| | NUMBER, WITH A DESCRIPTION OF THE REVISION MADE, |
| | IDENTIFYING THE SHEET OR SPECIFICATION PAGE WHERE |
| | CHANGES CAN BE FOUND WILL HELP TO EXPEDITE YOUR PERMIT. |
| | THANK YOU FOR YOUR ANTICIPATED COOPERATION. |
| | |
| | END OF COMMENTS: |
| | |
| | *IF THERE ARE ANY QUESTIONS PLEASE CALL. |
| | |
| | REVIEW BY: MIKE PERSON |
| | PLUMBING PLANS EXAMINER |
| | PHONE= (561) 805-6730 |
| | FAX= (561) 805-6731 |
| | E-MAIL= [email protected] |
