| Date |
Text |
| 2007-11-06 17:10:28 | |
| | |
| | DENIED |
| | |
| | 1)PLANS AND SPECIFICATIONS DESIGN PARAMETERS SHALL |
| | COMPLY WITH THE 2004 FLORIDA BLDG CODE WITH 2006 |
| | AMENDMENTS PER 106.1.1 FBC* |
| | |
| | 2)THE CLAIMED VALUATION ON THE PERMIT APPLICATION IS |
| | LOW. FOR PERMITTING PURPOSES, VALUATION OF BUILDINGS |
| | AND SYSTEMS SHALL BE THE TOTAL REPLACEMENT COST |
| | EXCLUDING LAND VALUE. OUR VALUATION REFERENCE IS ICC |
| | (BVD), MARSHALL-SWIFT AND MEANS COST ANALYSIS SERVICES |
| | PER 108.3 FBC* |
| | |
| | 3)THE STATE OF FLORIDA REQUIRES COLLECTION OF A RADON |
| | SURCHARGE ON ALL NEW CONSTRUCTION COMPUTED ON UNDER |
| | ROOF FLOOR SPACE PER 10D-91 FAC. THESE FEES WILL BE |
| | ADDED TO THE PERMIT APPLICATION FEES |
| | |
| | NOTE: FEES ARE DUE IN THE AMOUNT OF $163.33 FOR |
| | INCREASED VALUE AND STATE RADON FEES THIS AMOUNT IS |
| | REQUIRED TO BE PAID PRIOR TO FURTHER PLAN REVIEW |
| | |
| | 4)BEFORE A PERMIT TO CONSTRUCT, MAY BE ISSUED, IMPACT |
| | FEES MUST BE PAID TO PALM BEACH COUNTY. THE ACTUAL |
| | PERMIT SETS OF PLANS MUST BE STAMPED BY THAT OFFICE, |
| | AND A COPY OF THE PAID RECEIPT ATTACHED TO THE PERMIT |
| | APPLICATION. PLEASE CALL (561) 233-5025 FOR MORE |
| | INFORMATION. |
| | |
| | 5)MAKE CORRECTIONS TO ENERGY CALCULATIONS PLEASE NOTE |
| | THAT THE MIN WALL INSULATION ON THE SHORT FORM IS R-5 |
| | BUT CALCULATIONS SHOULD MATCH THE DRAWINGS WHICH STATE |
| | ON SHEET 2.1 THAT R-6 BATT WILL BE USED ON WALLS. |
| | |
| | 6)WINDOW PRODUCT APPROVALS ARE A COMBINATION OF |
| | DIFFERENT INFORMATION, THE STATE OF FLORIDA APPROVAL IS |
| | FOR MANY DIFFERENT MODELS ALL WITH DIFFERENT PRESSURE |
| | MAXIMUMS, THE STC TEST IS FOR A MODEL THAT IS NOT IN |
| | THE PRODUCT APPROVAL, THE MIAMI-DADE IS FORANOTHER |
| | MODEL AND THE DRAWINGS STATE TO USE TWO MORE MODELS. |
| | PLEASE PICK THE TYPE OF WINDOW AND SUBMIT THE PRODUCT |
| | APPROVAL FOR THAT WINDOW ONLY. (IF THE STC VALUE MEETS |
| | THE REQUIREMENTS THAT YOU NEED THAT IS OK BUT FOR PLAN |
| | REVIEW NO REQUIREMENTS NEED TO BE MET AND THE |
| | INFORMATION IS NOT REQUIRED) |
| | |
| | 7)WINDOW PRODUCT APPROVAL FROM MIAMI-DADE IS FOR |
| | NON-IMPACT WINDOWS THEREFORE IMPACT PROTECTION WILL BE |
| | REQUIRED. PLEASE SUBMIT SHUTTER PRODUCT APPROVALS. |
| | |
| | 8)DOOR PRODUCT APPROVALS ARE FOR SINGLE DOOR ONLY AND |
| | IS FOR A 7'-0" TALL DOOR. PLEASE SUBMIT PRODUCT |
| | APPROVAL FOR THE DOUBLE DOORS AND MEET THE 6'-8" THAT |
| | YOU REQUIRE. |
| | |
| | 9)NO PRODUCT APPROVALS WERE SUBMITTED FOR ASPHALT |
| | SHINGLES, PROPOSED SKYLIGHTS OR STORM SHUTTERS |
| | |
| | 10)MAXIMUM RISER HEIGHT AT DOORS TO LAUNDRY ROOM IS 7 |
| | 3/4" PLEASE MAKE CORRECTION ON DRAWINGS |
| | |
| | 11)SUBMIT ENGINEERED TRUSS DRAWINGS THAT COMPLY WITH |
| | R802.10.1 FBC WITH PERMIT APPLICATION OR BEFORE |
| | INSTALLATION THAT HAVE BEEN REVIEWED AND APPROVED BY |
| | THE DESIGNER OF RECORD |
| | |
| | 12)CORRECT MIN ROOF SHEATHING ATTACHMENT FOR ZONE 3 |
| | PER R803.2.3.1 FBC RES. |
| | |
| | 13)PROVIDE POURED/REINFORCED BLOCK CELL IN EXISTING |
| | BUILDING AT LOCATION OF EXISTING KITCHEN AND BATH AND |
| | THE INTERSECTION OF L-10 LINTEL THAT CARRIE ROOF LOAD |
| | OVER CONCRETE PATIO. |
| | |
| | 14)A RECORDED COPY OF THE NOTICE OF |
| | COMMENCEMENT IS REQUIRED PRIOR TO |
| | A PERMIT BEING ISSUED |
| | |
| | REMOVE ALL OLD PAGES AND RESUBMIT 2 COMPLETE SETS OF |
| | NEW DRAWINGS AND INCLUDE 1 COPY OF THE OLD PAGES ONLY |
| | FOR REFERENCE |
| | |
| | BLDG PLAN REVIEW |
| | ADRIAN MORSE |
| | 561-805-6716 |
| | |
| | |
| | |
| | |
| | |
| | |
| | |
| | |
| | |
| | |
