| Date |
Text |
| 2007-09-05 14:39:46 | 2004 FBC W/2007 SUPPLEMENTS |
| | LEVEL 3 ALTERATIONS |
| | |
| | DENIED BY BUILDING |
| | |
| | 1) THE SCOPE OF WORK ON THE PERMIT APPLICATION DOES NOT |
| | INDICATE WINDOW AND DOOR REPLACEMENT FOR THE MAIN HOUSE |
| | AND THE NOC SPECIFIES THE GARAGE/APARTMENT ONLY. PLEASE |
| | REMOVE THE WINDOW AND DOOR INFORMATION FOR THE MAIN |
| | HOUSE FROM THE SUBMITTAL. |
| | |
| | 2)SPECIFY THE WINDOW TYPES AND SIZES ON THE PLANS. |
| | FBC * 106.1.2 |
| | |
| | 3) SPECIFY THE WIDTH OF THE STAIRWAY ON THE |
| | PLANS.R311.5.1 STAIRWAYS SHALL NOT BE LESS THAN 36 |
| | INCHES (914 MM) IN CLEAR WIDTH AT ALL POINTS ABOVE THE |
| | PERMITTED HANDRAIL HEIGHT AND BELOW THE REQUIRED |
| | HEADROOM HEIGHT. HANDRAILS SHALL NOT PROJECT MORE THAN |
| | 4.5 INCHES (114 MM) ON EITHER SIDE OF THE STAIRWAY AND |
| | THE MINIMUM CLEAR WIDTH OF THE STAIRWAY AT AND BELOW |
| | THE HANDRAIL HEIGHT, INCLUDING TREADS AND LANDINGS, |
| | SHALL NOT BE LESS THAN 31.5 INCHES (787 MM) WHERE A |
| | HANDRAIL IS INSTALLED ON ONE SIDE AND 27 INCHES (698 |
| | MM) WHERE HANDRAILS ARE PROVIDED ON BOTH SIDES. |
| | |
| | 4) R 311.5.3.2 REQUIRES TREADS AND RISERS TO BE |
| | PROPORTIONED SO THAT THE SUM OF TWO RISERS AND A TREAD, |
| | EXCLUSIVE OF THE NOSING IS NOT LESS THAN 24 INCHES NOR |
| | MORE THAN 25 INCHES. SHOW COMPLIANCE. |
| | |
| | 5) SHOW COMPLIANCE WITH R311.2.2 UNDER STAIR |
| | PROTECTION. |
| | ENCLOSED ACCESSIBLE SPACE UNDER STAIRS SHALL HAVE |
| | WALLS, UNDER STAIR SURFACE AND ANY SOFFITS PROTECTED ON |
| | THE ENCLOSED SIDE WITH1/2-INCH (12.7 MM) GYPSUM |
| | BOARD. |
| | |
| | |
| | 6) SHOW COMPLIANCE WITH R311.4.1 AND R311.4.2 WHICH |
| | REQUIRE A SIDE HINGED EXIT DOOR NOT LESS THAN 3 FEET |
| | WIDE AND PROVIDING DIRECT ACCESS TO THE EXTERIOR |
| | WITHOUT TRAVELING THROUGH THE UTILITY/GARAGE. |
| | |
| | 7)PROVIDE STRUCTURAL DETAILS SPECIFYING HOW THE 2 X 8 |
| | FLOOR TRUSSES WILL BE SISTERED. SPECIFY THE FASTENERS, |
| | SPACING, ETC. |
| | |
| | 8) PROVIDE DETAILS AND SECTIONS SHOWING THE |
| | CONSTRUCTION AND SUPPORT OF FLOOR JOISTS AT THE NEW |
| | STAIRWAY. IF THE JOISTS ARE SUPPORTED BY A BEARING WALL |
| | BESIDE THE STAIRS SPECIFY THE FOUNDATION REQUIREMENTS. |
| | IF THE 3 MEMBER 2 X 8 BEAM IS CARRYING THE FLOOR LOAD |
| | SPECIFY THE CONNECTIONS AT THE EXTERIOR WALLS AND |
| | INDICATE HOW THE GRAVITY LOADS WILL BE TRANSFERRED TO |
| | THE FOUNDATION. |
| | |
| | 9) SPECIFY THE 2 X 8 JOIST SPACING AND SPANS. PLEASE |
| | REVIEW FOR ALLOWABLE DEFLECTION. SEE TABLE R 301.7. |
| | NOTE: TABLE R 301.5 REQUIRES A LIVE LOAD OF 30 PSF FOR |
| | SLEEPING ROOMS AND 40 PSF FOR OTHER ROOMS AND STAIRS. |
| | |
| | |
| | 10) THERE APPEARS TO BE A CONFLICT WITH THE PROPOSED |
| | FLOOR PLAN AND THE STAIR SECTION. THE FLOOR PLAN SHOWS |
| | AN INTERIOR WALL BESIDE THE STAIRS AND THE STAIR |
| | SECTION SHOWS A WALL UNDER THE STAIR STRINGERS. PLEASE |
| | CLARIFY. |
| | |
| | 11) WPB ADMIN CODE 106.3* PRODUCT |
| | APPROVALS. THOSE PRODUCT WHICH ARE |
| | REGULATED BY DCA RULE 9B-72 SHALL BE |
| | REVIEWED AND APPROVED IN WRITING BY THE |
| | DESIGNER OF RECORD PRIOR TO SUBMITTAL |
| | FOR JURISDICTIONAL APPROVAL. |
| | |
| | 12) THE PRODUCT APPROVAL FOR THE OVERHEAD GARAGE DOOR |
| | IS EXPIRED. SUBMIT TWO COPIES OF THE CURRENT PRODUCT |
| | APPROVALS. (NOA NO. 05-0915.08) |
| | |
| | 13) THE PRODUCT APPROVALS FOR THE STOREFRONT DOOR IS |
| | EXPIRED AND INCOMPLETE. THERE ARE NOT ANY STOREFRONT |
| | DOORS SHOWN ON THE PLANS. SUBMIT TWO CURRENT AND |
| | COMPLETE PRODUCT APPROVALS FOR THE SINGLE AND DOUBLE |
| | OUTSWING DOORS. |
| | |
| | 14)SUBMIT TWO COPIES OF THE COMPLETE NOA, INCLUDING |
| | THE INSTALLATION DRAWINGS FOR THE SINGLE HUNG WINDOWS. |
| | ONLY THE FIRST PAGE OF THE NOA WAS SUBMITTED. |
| | |
| | 15) SUBMIT PRODUCT APPROVALS FOR LARGE MISSILE IMPACT |
| | RATED MULLIONS. |
| | |
| | 16) R309.2 SEPARATION REQUIRED. |
| | THE GARAGE SHALL BE SEPARATED FROM THE RESIDENCE AND |
| | ITS ATTIC AREA BY NOT LESS THAN ? -INCH (12.7 MM) |
| | GYPSUM BOARD APPLIED TO THE GARAGE SIDE. GARAGES |
| | BENEATH HABITABLE ROOMS SHALL BE SEPARATED FROM ALL |
| | HABITABLE ROOMS ABOVE BY NOT LESS THAN 5 / 8 -INCH |
| | (15.9 MM) TYPE X GYPSUM BOARD OR EQUIVALENT. WHERE THE |
| | SEPARATION IS A FLOOR-CEILING ASSEMBLY, THE STRUCTURE |
| | SUPPORTING THE SEPARATION SHALL ALSO BE PROTECTED BY |
| | NOT LESS THAN ?-INCH (12.7 MM) GYPSUM BOARD OR |
| | EQUIVALENT. |
| | |
| | 17) SHOW COMPLIANCE WITH R309.2 SEPARATION REQUIRED. |
| | THE GARAGE SHALL BE SEPARATED FROM THE RESIDENCE AND |
| | ITS ATTIC AREA BY NOT LESS THAN ? -INCH (12.7 MM) |
| | GYPSUM BOARD APPLIED TO THE GARAGE SIDE. GARAGES |
| | BENEATH HABITABLE ROOMS SHALL BE SEPARATED FROM ALL |
| | HABITABLE ROOMS ABOVE BY NOT LESS THAN 5 / 8 -INCH |
| | (15.9 MM) TYPE X GYPSUM BOARD OR EQUIVALENT. WHERE THE |
| | SEPARATION IS A FLOOR-CEILING ASSEMBLY, THE STRUCTURE |
| | SUPPORTING THE SEPARATION SHALL ALSO BE PROTECTED BY |
| | NOT LESS THAN ?-INCH (12.7 MM) GYPSUM BOARD OR |
| | EQUIVALENT. |
| | |
| | 18) SHOW COMPLIANCE WITH R313 FOR SMOKE ALARMS. |
| | |
| | ROBERT MCDOUGAL |
| | BLDG. PLAN REVIEW |
| | (561)805-6714 |
| | [email protected] |
