| Date |
Text |
| 2007-07-11 14:33:20 | |
| | |
| | DENIED |
| | |
| | 1)BEFORE A PERMIT TO CONSTRUCT, MAY |
| | BE ISSUED, IMPACT FEES MUST BE PAID TO PALM BEACH |
| | COUNTY. THE ACTUAL PERMIT |
| | SETS OF PLANS MUST BE STAMPED BY THAT |
| | OFFICE, AND A COPY OF THE PAID RECEIPT |
| | ATTACHED TO THE PERMIT APPLICATION. |
| | PLEASE CALL (561) 233-5025 FOR MORE INFORMATION. |
| | |
| | NOTE: COUNTY STAMP STATES THAT NO ADDITIONAL SPACE, YET |
| | DRAWINGS AND PERMIT STATE THAT ADDITION IS BEING BUILT. |
| | COUNTY FEES ARE TO BE PAID FOR ADDITION OR PROVIDE A |
| | LETTER FROM COUNTY THAT NONE ARE REQUIRED FOR THE |
| | ADDITION. |
| | |
| | 2)THE STATE OF FLORIDA REQUIRES COLLECTION OF A RADON |
| | SURCHARGE ON ALL NEW CONSTRUCTION COMPUTED ON UNDER |
| | ROOF FLOOR SPACE PER 10D-91 FAC. THESE FEES WILL BE |
| | ADDED TO THE PERMIT APPLICATION FEES |
| | |
| | 3)THE PERMIT APPLICATION SHALL INCLUDE TWO COPIES OF |
| | EACH PRODUCT APPROVAL THAT |
| | IS RELEVANT PER 9B-72. THESE SHOULD INCLUDE THE FLORIDA |
| | STATE APPROVAL COVER PAGES, AND THE PRODUCT NOA THAT |
| | LISTS THE SYSTEM COMPONENTS/ FASTENER LIST PAGES. ALL |
| | CAN BE FOUND ON WWW.FLORIDABUILDING.ORG |
| | |
| | 4)THE CITY OF WEST PALM BEACH REQUIRES THE FLORIDA |
| | STATE PRODUCT APPROVAL COVER |
| | SHEETS WHEN AVAILABLE. THEY CAN BE SEARCHED FOR ON |
| | WWW.FLORIDABUILDING.ORG.WHEN AVAILABLE AND NOT |
| | SUBMITTED APPLICATIONS WILL BE DENIED |
| | |
| | 5)THOSE PRODUCTS WHICH ARE REGULATED BY DCA RULE |
| | 9B-72 (PRODUCT APPROVALS) SHALL BE REVIEWED AND |
| | APPROVED IN WRITING BY THE DESIGNER OF RECORD PRIOR TO |
| | SUBMITTAL FOR JURISDICTIONAL APPROVAL PER 106.3.3 FBC* |
| | |
| | |
| | 6)SUBMIT TWO COPIES OF ENERGY CALC'S PER 13-101.2.2 |
| | FBC. BE SURE THAT THEY ARE SIGNED AND |
| | DATED BY PREPARER AND OWNER/AGENT PRIOR |
| | TO SUBMITTAL |
| | |
| | NOTE: THE COPIES THAT WERE SUBMITTED ARE NOT SIGNED BY |
| | THE OWNER/AGENT. |
| | |
| | 7)PHOTO COPIED, STAMPED OR REPRODUCED SIGNATURES ARE |
| | NOT ACCEPTABLE PER 471.025 F.S. PLEASE SEE THAT |
| | ENGINEERS SIGNATURE ON THE SOIL REPORT IS A PHOTOCOPY |
| | ALSO THE REPORT STATES THAT IT IS IN ACCORDANCE WITH |
| | THE 2001 FBC |
| | |
| | 8)PLANS AND SPECIFICATIONS DESIGN PARAMETERS SHALL |
| | COMPLY WITH THE 2004 FLORIDA BLDG CODE WITH 2006 |
| | AMENDMENTS |
| | |
| | 9)PROVIDE THE COMPLETE WIND DESIGN DATA THAT APPLIES |
| | TO BUILDING PER 1603.1.4 FBC |
| | |
| | 10)IN AN EXISTING BUILDING WHERE ALTERATIONS ARE |
| | BEING MADE A DESIGN PROFESSIONAL MUST ELECT THE LEVEL |
| | OF ALTERATION PER 301.5 OF EXISTING BUILDING CODE AND |
| | STATE ALONG WITH THE TYPE OF CONSTRUCTION ON THE |
| | DRAWINGS |
| | |
| | 11)PROVIDE 2 COPIES OF A RECENT SURVEY SHOWING THE |
| | PROPOSED BUILDING/ADDITION WITH ALL SIDE AND REAR |
| | SETBACKS |
| | |
| | 12)PROVIDE A SITE PLAN THAT SHOWS DRAINAGE IN |
| | COMPLIANCE WITH THE REQUIREMENTS OF R403.1 FBC RES. |
| | |
| | 13)PROVIDE SMOKE ALARMS TO EXISTING BUILDING PER |
| | R313.1.1 FBC RES. |
| | |
| | 14)PROVIDE MIN ROOF SHEATHING ATTACHMENT |
| | PER R803.2.3.1 FBC RES. 2006 AMENDMENTS SPECIFY 8D RING |
| | NAILS AT 6" O/C FIELD AND EDGE AND 4" O/C FIELD AND |
| | EDGE IN ZONE 2 & 3 |
| | |
| | 15)A DESIGN PROFESSIONAL THAT IS REGISTERED TO |
| | PRACTICE UNDER CHAPTER 481 OR 471 OF |
| | THE FLORIDA STATUTES SHALL AFFIX THEIR OFFICIAL SEAL, |
| | SIGNATURE AND DATE TO SAID DRAWINGS AND SPECIFICATIONS |
| | PER 106.1 FBC 2004. PLEASE NOTE THAT ONLY ONE COPY OF |
| | DRAWING HAS BEEN SIGNED ANDNEITHER WAS DATED |
| | |
| | 16)PROVIDE ATTIC ACCESS ON DRAWINGS TO ALL AREAS AS |
| | REQUIRED PER R807.1 FBC RES. WITH 30" CLEAR ABOVE |
| | OPENING |
| | |
| | 17)SUBMIT ENGINEERED TRUSS DRAWINGS THAT |
| | COMPLY WITH R802.10.1 FBC WITH PERMIT |
| | APPLICATION OR BEFORE INSTALLATION THAT |
| | HAVE BEEN REVIEWED AND APPROVED BY THE |
| | DESIGNER OF RECORD |
| | |
| | 18)SPECIFY PT WOOD PLATE AT LOCATIONS WHERE REQUIRED |
| | PER 319.1 FBC RES. |
| | |
| | 19)DRAWINGS STATE FIXED WINDOWS IN ALL LOCATIONS AND |
| | THE PRODUCT APPROVALS THAT WERE SUBMITTED ARE FOR |
| | AWNING TYPE. ALSO THE DESIGN PRESSURE MAXIMUM IS -50 |
| | PSF AND THE DESIGN LOADS GIVEN ARE -50.7 PSF IN ZONE 4 |
| | AND -59.7 PSF IN ZONE 5 |
| | |
| | 20)DRAWINGS SHOW 4 NEW SLIDING GLASS DOORS AND NO SGD |
| | PRODUCT APPROVALS WERE SUBMITTED |
| | |
| | 21)A RECORDED COPY OF THE NOTICE OF |
| | COMMENCEMENT IS REQUIRED PRIOR TO |
| | A PERMIT BEING ISSUED |
| | |
| | BLDG PLAN REVIEW |
| | ADRIAN MORSE |
| | 561-805-6716 |
| | |
| | |
| | |
| | |
| | |
| | |
| | |
| | |
| | |
| | |
| | |
| | |
| | |
| | |
| | |
