| Date |
Text |
| 2005-08-13 00:00:00 | PAUL SCHMITZ, PLUMBING PLANS EXAMINER |
| | [email protected] |
| | |
| | PLUMBING PLAN REVIEW FBC 2001 |
| | DENIED |
| | (1) SEC 1012.1.4 REST ROOM DOOR SWING. |
| | SHT 1. PROVIDE FLOOR PLAN TO SHOW AREA |
| | NEW DOOR WILL BE OPENING INTO. |
| | (2) ?P310.4 WATER CLOSET COMPARTMENT. |
| | EACH WATER CLOSET UTILIZED BY THE |
| | PUBLIC OR EMPLOYEES SHALL OCCUPY A |
| | SEPARATE COMPARTMENT WITH A DOOR AND |
| | WALLS OR PARTITIONS BETWEEN FIXTURES TO |
| | ENSURE PRIVACY. |
| | |
| | (3) INDICATE THE CLEAR FLOOR SPACE AT |
| | LAVATORY AND WATER CLOSET. FBC 11-4.19.3 |
| | AND 11-4.16.2 |
| | |
| | (4) INDICATE THE UNOBSTRUCTED TURNING |
| | SPACE REQUIRED BY FBC 11-4.22.3. |
| | |
| | (5) PROVIDE BATHROOM ELEVATIONS ON THE |
| | PLANS. SHOW THE REQUIRED LOCATIONS |
| | CLEARANCES AND HEIGHTS OF ALL ACCESSIBLE |
| | FIXTURES. FBC CHAPTER 11. |
| | |
| | (7) THE DISTANCE FROM THE WALL TO THE |
| | CENTER OF THE WATER CLOSET IS 18". SEE |
| | FBC CHAP.11 FIGURE 28. |
| | |
| | (8) SIDE GRAB BAR IS REQUIRED TO BE 12" |
| | OFF THE REAR WALL. SEE FIGURE 29. |
| | |
| | (9) MIRRORS MUST COMPLY WITH FBC |
| | 11-4.19.6. |
| | |
| | (10) BREAK ROOM SINK |
| | ?11-4.24 SINKS. |
| | ?11-4.24.1 GENERAL. SINKS REQUIRED TO |
| | BE ACCESSIBLE BY ?11-4.1 SHALL |
| | COMPLY WITH ?11-4.24. |
| | |
| | ?11-4.24.2 HEIGHT. SINKS SHALL BE |
| | MOUNTED WITH THE COUNTER OR RIM NO |
| | HIGHER THAN 34 IN. (865 MM) ABOVE THE |
| | FINISH FLOOR. |
| | |
| | ?11-4.24.3 KNEE CLEARANCE. KNEE |
| | CLEARANCE THAT IS AT LEAST 27 IN. (685 |
| | MM) HIGH, 30 IN. (760 MM) WIDE, AND 19 |
| | IN (485 MM) DEEP SHALL BE |
| | PROVIDED UNDERNEATH SINKS. |
| | |
| | ?11-4.24.4 DEPTH. EACH SINK SHALL BE A |
| | MAXIMUM OF 6-1/2 IN (165 MM) |
| | DEEP. |
| | |
| | ?11-4.24.5 CLEAR FLOOR SPACE. A CLEAR |
| | FLOOR SPACE AT LEAST 30 IN. BY 48 |
| | IN. (760 MM BY 1220 MM) COMPLYING WITH |
| | 11-4.2.4 SHALL BE PROVIDED IN |
| | FRONT OF A SINK TO ALLOW FORWARD |
| | APPROACH.THE CLEAR FLOOR SPACE SHALL |
| | BE ON AN ACCESSIBLE ROUTE AND SHALL |
| | EXTEND A MAXIMUM OF 19 IN. (485 MM) |
| | UNDERNEATH THE SINK (SEE FIGURE |
| | 11-32). |
| | |
| | ?11-4.24.6 EXPOSED PIPES AND SURFACES. |
| | HOT WATER AND DRAIN PIPES EXPOSED |
| | UNDER SINKS SHALL BE INSULATED OR |
| | OTHERWISE CONFIGURED SO AS TO PROTECT |
| | AGAINST CONTACT.THERE SHALL BE NO |
| | SHARP OR ABRASIVE SURFACES UNDER |
| | SINKS. |
| | |
| | ?11-4.24.7 FAUCETS. FAUCETS SHALL |
| | COMPLY WITH ?11-4.27.4.LEVER- |
| | OPERATED, PUSH-TYPE, TOUCH-TYPE, OR |
| | ELECTRONICALLY CONTROLLED MECHANISMS |
| | ARE ACCEPTABLE DESIGNS. |
| | |
| | IF THERE ANY QUESTIONS, DO NOT |
| | HESITATE TO CALL. |
