| 2008-05-15 15:11:01 | |
| | |
| | DENIED |
| | |
| | 1) PLEASE MAKE THE FOLLOWING CORRECTIONS TO THE SHUTTER |
| | SCHEDULE |
| | |
| | A) THE EDGE DISTANCE FOR BOTH THE ACCORDIONS AND THE |
| | PANELS IS 3 1/2" FOR THE MAXIMUM ON CENTER SPACING |
| | SHOWN, IF E.D. IS SMALLER PLEASE NOTE THE TABLES ON |
| | PAGES 6 & 7 OF THE PANEL DRAWINGS AND PAGE 11 OF THE |
| | ACCORDIONS. SMALLER EDGE DISTANCE REQUIRES THE O/C |
| | SPACING TO BE MULTIPLIED BY THE FACTOR IN THESE TABLES |
| | WHICH IN TURN WILL ADJUST THE SPACING DISTANCE. UNDER |
| | NO CIRCUMSTANCE CAN 1" BE USED AS STATED IN YOUR |
| | SCHEDULE, THE MINIMUM EDGE DISTANCE IS 2". |
| | |
| | B) PANEL LENGTHS ON AVERAGE ARE OPENING WIDTH OR HEIGHT |
| | PLUS EDGE DISTANCE X 2, (7") PLUS APPROX 2" FOR PANEL |
| | PAST THE MOUNTING SCREW |
| | |
| | C) IN THE PANEL MOUNTING TYPE COLUMN YOU SHOULD ENTER |
| | THE MOUNTING METHOD USED (PAGES 3,4 & 5) NOT THE PARTS |
| | FROM PAGE 1A, PLEASE NOTE THAT THESE MOUNTING METHODS |
| | ARE IN THE LAST COLUMNS OF THE O/C SPACING TABLES |
| | |
| | D) THE SAME IDEA APPLIES TO THE ACCORDION SHUTTERS FOR |
| | MOUNTING TYPE (SEE PAGE 5) IF 2 AND 4 ARE CHOSEN ONLY |
| | COLUMNS 2 AND 4 ON SHEET 10 WOULD APPLY, THEREFORE THE |
| | O/C SPACING FOR SHUTTERS 11 AND 12 WHICH ARE OVER 7'-0" |
| | SPAN WOULD BE 7.5" |
| | |
| | E) SHUTTER PANEL FOR OPENING # 2 WHEN PANEL LENGTH IS |
| | CORRECTED PER FORMULA IN NOTE "A" EXCEEDS THE MAXIMUM |
| | PANEL LENGTH ALLOWED PER TABLE ON SHEET 5 IF H HEADER |
| | IS USED, BUT WOULD BE ALRIGHT IF DIRECT MOUNTED TO |
| | WALL |
| | |
| | F) PLEASE SEE NOTE ON PAGE 5 OF PANEL DRAWINGS, 3'-0" |
| | IS MINIMUM PANEL LENGTH THEREFORE OPENING # 14 PANELS |
| | ARE REQUIRED TO BE LENGTHENED OR INSTALLED |
| | HORIZONTALLY |
| | |
| | 2) SUBMIT 2 COPIES OF CORRECTED SHUTTER SCHEDULE |
| | |
| | 3) MAKE CORRECTIONS TO DRAWINGS THAT REFLECT THE WORK |
| | TO BE PERFORMED |
| | |
| | BLDG PLAN REVIEW |
| | ADRIAN MORSE |
| | 561-805-6716 |
| | |
| | |
| | |
